Installation, 1 installation, Notice - important – ChemoMetec NC-100 User Manual

Page 11

1 Installation

When the NucleoCounter is connected to a computer running NucleoView it is possible to

chamber. Connecting a NucleoCounter to a computer does not affect the operation of the

NucleoCounter in any way and the NucleoView software performs no additional image

analysis.

The installation

procedures below describe the installation of the NucleoView software

and the USB driver on computers running Windows 7. It is possible to install NucleoView

and the USB driver on computers running other operating systems than Windows 7. For a

list of supported operating systems please refer to chapter 8 Technical specifications.

The communication between the NucleoCounter and NucleoView is based on the USB 1.1

protocol, thus the computer must be equipped with an USB 1.1 compatible port.

NOTICE - IMPORTANT!

Before installation of NucleoView Package ver. 2.3, check if an older version

of NucleoView is installed on the computer.

Any other version of NucleoView is most likely to be located in the folder

C:\Nucleoview.

If present it must be uninstalled by executing the uninst.exe file placed in

the folder C:\Nucleoview.

If no older version of NucleoView is installed on the computer follow the directions in

If an older version of NucleoView is installed on the computer, it has to be uninstalled

before NucleoView Package ver. 2.3 can be installed. Follow the 3 steps below.

1. Uninstall the older version of NucleoView (see chapter 1.2.1 Removal of

2. Install NucleoView Package ver. 2.3 by following the directions in chapter

The NucleoCounter will then be ready for use with the NucleoView software ver. 2.2

This installation is called ”NucleoView Package ver. 2.3”, since it contains a new driver for

64-bit OS also. However the actual NucleoView program is still ver. 2.2.

This manual is related to the following products: