Panasonic KX-F1110NZ - Manual (Page 51)

Operating the answering device from a remote
telephone -■
The following operations can be performed from a remote location using a touch tone telephone.
Set the unit to ANS/FAX in the AUTO RECEIVE mode before going out (see page 24).
Dial key
n i H i t u l i l t ! , 1
.
i *
t i 1
j * t # * *
; M
.
1 1 i i
J
« t -
■. s
i
i
(
■ i^aga ;
■ i t®
Skips the greeting message 55
i 4 1 ■* *
)—,11
01
^ -f. ^ J
.......
Stops re-recording of a greeting
message
55
Repeats a message 53
^ L k | i 1 ^
! Hw'f ^
Erases a specific message 54
: 0
Skips a message 53
ii?i:
Erases all messages 54
Changes to the TEL mode 55
New message playback 53
so
f . i t *
1 . É » t # 5
Turns on message transfer/
pager call for incoming messages
55
All message playback 53
* ■*
t
® i ^
Turns off message transfer/
pager call for incoming messages
55
0
Re-records a greeting message 55
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
Answering Device Remote
1
i
1
i
1
Notice of Remote Operation
Operation i
i
1
1. Call your unit.
2. Enter the remote operation ID
I I I I during the greeting
message.
3. Press the remote command
key(s) (see the reverse side)
within 4 seconds.
or
Wait for 4 seconds. All the
recorded messages will be
played back.
•The remote operation is
available only from a touch tone
telephone when the unit is in the
ANS/FAX mode.
•When the unit is in the TEL
mode, call your unit and wait for
15 rings.
The answering system will
temporarily answer the line.
Enter the remote operation ID
during the greeting message.
The unit will switch to the
ANS/FAX mode.
•When you press any key, press
firmly.
•To send a document, press
@0. When a fax tone is heard,
start transmission.
51