Panasonic SC-DK10 - Manual (Page 45)

□
CLOCK/
TIMER
©PLAY/
0REC
&
rSQ ii-OJ
,
:
©
1
'1
T “
!ÍÍ¡
€>> 'Mh0
S -
w
Ì CO) V®)
p:i cj
& O’ O
B fflg «
tì m M
flm'^ B
c.::S Clio
.. ZL_.:-^ii::rE==^
SLEEP
AUTO OFF
SLEEP
f~ I c c c<
III (_ )" c r
n¡
_( U'
Using the timers
1itte[gtesyaHilHg03ì;a(fl^^
Turning the timers on and off
The selected timer comes on at the set time if the indicator {“©PLAY”
or “©REC") is on. The timer can be turned on and off by pressing
[©PLAY/OREC],
Checking the timers
• While the unit is on
Press [CLOCKCriMER] to seiect “©PLAY” or “®REC”.
The set timer conditions are shown in thefollowing order.
Play timer:
start time^finish time-»source^ volume
Record timer:
start time^finish time—> source
•While the unit is off
Press [CLOCK/TIMER],
The clock and the indicator for the timer that is on are shown.
Playing the unit after the timers are set
The unit can be used after the timers are set.
Check the following before turning the unit off again.
If playing tapes or making a recording:
Reset tape direction.
If playing discs:
Make sure the desired disc is selected.
?
o
£
o
•O
c
(t)
.E
iiz
• If you turn the unit off and on again whiie a timer is functioning, the
finish time setting wiii not be activated.
• If the unit is on, the timer wiii not function. The unit must be in the
standby mode.
• If AUX is seiected as the source, when the timer comes on, the
system turns on and engages AUX as the source. If you want to
playback or record from a connected unit, set the other unit’s timer
to the same time. (See the other unit’s instruction manuai.)
•The record timer cannot be used with DVDs and Video CDs.
•The timer cannot be used to start the CD MANAGER or program
play.
lite ePasit) tea?
Remote control only
This timer turns the unit off after a set time.
Press [SLEEP] to select the time (minutes).
Each time you press the button:
SLEEP 30------->SLEEP 60------- »SLEEP 90
t—SLEEP OFF»------- SLEEP 120»------ '
To cancel the sleep timer
Press [SLEEP] to seiect "SLEEP OFF"
To confirm the remaining time
Whiie the timer is functioning
Press [SLEEP].
The remaining time is shown for about 5 seconds.
To change the setting
Press [SLEEP] to dispiay the remaining time, then press again to se­
iect the required time.
OM áei te teses Qseiatei?
The play and sleep timers or the record and sleep timers can be used
together.
The sleep timer always has priority. Be sure not to overlap timer
settings.
The play and record timers cannot be used together.
RQT5824