CANOGA PERKINS 9145 Network Interface Device - Manual (Page 80)

4-6 9145 Network Interface Device
through the options. Press to select option.
Drop Probability
Sets IP packet Discard Priority. Options are Low, Medium, High, not used
7. Test Packet Priority
Sets VLAN frame priority. 0 to 7
8. Test Duration min:sec
Test duration in minutes and seconds, 0 for a continuous test
9. Min Test Packet Size
Sets minimum packet size. 40 to 1472 bytes
10. Max Test Packet Size
Sets maximum packet size. Must be equal to or greater than the Minimum
Packet Size. The 9145 increments packet size from the minimum to the
maximum when the next packet is sent during a test. When the maximum size
has been sent, the size is reset to the minimum size and the incrementing
continues. Maximum packet size is from 40 to 1472 bytes.
11. Test Packet Timeout
How long to wait for a test packet to return
12. Start/Stop Test
Starts the test or stops the test prior to automatic completion or when in
Continuous (Duration setting of 0).
13. Remote Latency Test
Initiates and configures Latency and Jitter testing on a Remote 9145 when
SBMC is enables.
3. When the Latency/Jitter test is finish running, press to return to the Diagnostics
Menu.
PING Testing
To verify network connectivity with another IP device such as another 9145, an Ethernet
Switch, or a user host, you can use the 9145 to send a PING to the IP address for that
device. Use the PING Generation Screen to send the PING To set up and send a PING,
follow these steps: