BendixKing KLN 94 - Pilots Guide - Manual (Page 86)

4. Rotate the right inner knob to
select the desired range (figure
3-126). Range scales greater
than that selected will not display
the selected item. Range scales
equal to or less than that select-
ed will display the item.
5. Use the right inner and outer knobs to finish configuring the rest of the
aeronautical items for the map.
6. Press the
R
button or
M
button to return to the map.
NOTE: Each aeronautical item has a factory set default range value. To
change an individual item to the default value place the cursor over the
range field to the right of the desired item and press the
E button. To
change all aeronautical items to their default ranges, place the cursor over
“Restore Dfaults?” on line 3 and press the
F button.
3.11.4.5. Runway Diagrams
If the selected map range scale is 5 NM (7 km) or less, runway diagrams
are depicted along with the airport symbol.
3.11.4.6. Configuring Land Data On The Map
The SET 8 page is used to configure the land data for the map. The fol-
lowing items may be configured on this page:
• Cities/towns – large, medium, and small
• Roads – freeways, national highways, local highways
• Lakes and Rivers
• Railroads
• Geographical boundary lines
• Obstacles – towers less than1000 ft. AGL and those 1000 ft. AGL
and greater
NOTE: At the time this Pilot’s Guide was written, obstacle data is only
available for the United States.
Each of the above items may be turned on or off individually. The item is
turned on by selected the maximum map range scale you want the item to
be displayed.
Chapter 3 Basic GPS Operation
3-44
Figure 3-126