BendixKing KLN 94 - Pilots Guide - Manual (Page 127)

ing GPS signals suitable for navigation. (Note: If the unit is in the
take-home mode, it has been “tricked” into thinking it is receiving
signals and therefore the symbol can be displayed). Also, the sym-
bol will not be displayed if Direct To navigation is occurring and the
Direct To waypoint is not in
FPL 0. If in doubt as to
whether or not Direct To oper-
ation is occurring, view the
NAV 1 page. If the top line
shows the
$
symbol (figure
4-29) instead of a “from” way-
point (figure 4-30), then Direct
To navigation is occurring. If it
is desired to cancel the Direct
To operation and operate from
the active flight plan, press
D, E, and then F.
• As flight plan waypoints are reached, the active leg symbol auto-
matically shifts to the next leg.
• If the flight plan contains more
waypoints than can be dis-
played on the screen at one
time, the page will automatical-
ly scroll as progress is made
along the flight plan so that the
active leg is always displayed
(figure 4-31).
• The last waypoint in the flight plan is always displayed at the bottom
of the FPL 0 page, even if all of the waypoints in the flight plan can’t
be displayed on the page at one time. To view intermediate way-
points, turn the cursor on and use the right outer knob to manually
scroll through all of the way-
points, as desired. If scrolling
is performed all the way to the
end of the flight plan, a blank
waypoint position will exist so
that a waypoint may be added
to the end of the flight plan
(figure 4-32).
KLN 94 Pilot’s Guide Chapter 4 Flight Plan Operation
4-9
Figure 4-29
Figure 4-30
Figure 4-31
Figure 4-32