BendixKing KLN 94 - Pilots Guide - Manual (Page 49)

10. The Database page will now be displayed with the cursor over
Acknowledge?. Line 1 indicates whether an Americas, Atlantic
International, or Pacific International aeronautical database is being
used. If the aeronautical database (airports, navaids, approaches, etc)
is current, line 2 will show the date when the aeronautical database
expires (figure 3-18). If the aeronautical database is out of date, line 2
shows the date that it expired (figure 3-19). The KLN 94 will still func-
tion with an out-of-date aeronautical database; however, you must
exercise extreme caution and
always verify that the database
information is correct before
using information from an out-of-
date aeronautical database.
Line 3 indicates which database
region is used for the LAND
database (roads, rivers, etc) on
ORS 02 and higher units. Line 4
displays the date that the land
database was created. The
land database has no expiration
date and new data is available
approximately once a year.
Press
F to acknowledge the information on the Database page.
The first time the KLN 94 is turned on after a new database card was
inserted, it takes approximately seven minutes to download data from the
card to internal memory. During this time the Database page will tem-
porarily display:
*STANDBY*
Database being
Updated
When the download is complete the normal database page will be dis-
played.
WARNING: The accuracy of the database information is assured
only if the database is current. Operators using an out-of-date data-
base do so entirely at their own risk.
NOTE: If your KLN 94 is interfaced
with a remote Shadin fuel/air data
computer but no fuel flow indicator,
the Fuel on Board page will be dis-
played following the Database page
(figure 3-20). This page allows you to
KLN 94 Pilot’s Guide Chapter 3 Basic GPS Operation
3-7
Figure 3-18
Figure 3-19
Figure 3-20