Waterworks Formwork Wall Mounted Tub Spout - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
FORMWORK
Wall Mounted Tub Spout Installation Guidelines
Page 1 of 2
Rev - 01
4.8.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
FORMWORK WALL MOUNTED TUB SPOUT (STYLE No. FMTS01)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
STYLE No. FMTS01
SPECIFICATIONS:
Fittings Hole Diameter: Ø1-1/4"
Inlet Connection Size: 1/2"
Inlet Connection Type: Female NPT
Integrated Diverter: No
Water Pressure Minimum: 20psi
Water Pressure Maximum: 80psi
Water Pressure Recommended: 45psi
IMPORTANT:
¾ To ensure this product is installed properly, you must
read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ This product must be installed by a professional
licensed contractor.
¾ Be sure your installation conforms to all federal, state,
and local codes.
¾ In the State of Massachusetts, all installations must
comply with the rules and regulations set forth within
248 CMR.
¾ Refer to the specification and assembly drawings
attached. Product is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.
¾ Inspect the product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ DO NOT use putty. Putty contains oil and can cause
permanent discoloration on certain materials such as
marble, granite and any porous surface.
TRIM INSTALLATION:
¾ The inlet of the SPOUT is 1/2" Female NPT.
1. Install a 1/2" NPT NIPPLE (NOT INCLUDED) as shown
in Figure - 01.
FIGURE - 01
2. Ensure the front face of NIPPLE is 3/16" from the
finished wall as shown in Figure - 02.
FIGURE - 02
FINISHED WALL
1/2" NPT NIPPLE
(NOT SUPPLIED)
FINISHED WALL
1/2" NPT NIPPLE
(NOT SUPPLIED)
FINISHED WALL
1/2" NPT NIPPLE
(NOT SUPPLIED)
3/16"
FACE OF NIPPLE
BEHIND
FINISHED WALL
FINISHED WALL
1/2" NPT NIPPLE
(NOT SUPPLIED)