Waterworks Formwork Floor Mounted Exposed Tub Filler with Handshower and Metal Jostick Handle - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
FORMWORK
Floor Mounted Exposed Tub Filler Installation Guidelines
Page 1 of 4
Rev - 01
8.18.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
FORMWORK FLOOR MOUNTED EXPOSED TUB FILLER WITH METAL JOYSTICK HANDLE [STYLE No. FMXT70,
FM70XT (UK)] & FORMWORK FLOOR MOUNTED EXPOSED TUB FILLER WITH HANDSHOWER AND METAL
JOYSTICK HANDLE [STYLE No. FMXT90, FM90XT (UK)]
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
STYLE No. FMXT70† STYLE No. FMXT90†
with Metal Joystick Handle with Handshower and
Metal Joystick Handle
SPECIFICATIONS:
Anti-scald Protection: No
Inlet Connection Size & Type: 1/2" Female NPT†
Fittings Hole Diameter: Ø3-7/8" (98mm)
Hot Limit Safety Stop: No
Integrated Diverter: No
Spout Reach: 8-7/8" (225mm)
Water Pressure Minimum: 20 psi (1.4 Bar)
Water Pressure Maximum: 80 psi (5.5 Bar)
Water Pressure Recommended: 45 psi (3 Bar)
Unrestricted Flow Rate: 8 - 10 gpm (30 – 38 L)
† UK Style No.
FM70XT & FM90XT are supplied with 2
BSP adapters, assembly required.
IMPORTANT:

To ensure this product is installed properly, you must
read and follow these guidelines. The owner/user of
this product must keep this information for future
reference.
 This product must be on-site prior to rough-in. This
allows the installer to visualize the installation and
verify the center spread.
 This product must be installed by a professional
licensed contractor.
 Check tub measurements to assure the spout projects
far enough into the tub.
 Install accessible hot and cold service stop valves to
facilitate servicing

Be sure your installation conforms to all federal, state,
and local codes.
 Anti-scald protection is the responsibility of the
installer and according to applicable codes.
 In the State of Massachusetts, all installations must
comply with the rules and regulations set forth within
248 CMR.
 Refer to the specification and assembly drawings
attached. Product is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.
 Inspect the product to ensure you have all the parts
required for proper installation.
 Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
 Run 1/2" supply lines for maximum flow.

DO NOT use putty. Putty contains oil and can cause
permanent discoloration on certain materials such as
marble, granite and any porous surface.
ROUGH-IN:

The MOUNTING PLATE is 2-1/2" in height and should
be a minimum of 3/4" from the surface of the finished
floor as shown in Figure - 01.
FIGURE – 01
BLOCKING
SUB-FLOOR
FINISHED
FLOOR
MOUNTING
PLATE
BLOCKING
SUB-FLOOR
FINISHED
FLOOR
MOUNTING
PLATE
2-1/2"
3/4"
MIN
Ш3-7/8"
7/8"