beautypg.com

Installation guidelines – Waterworks Easton Classic Three Cross Handle Exposed Thermostatic System with Shower Rose and Handshower User Manual

Page 2

background image


PRODUCT SUPPORT 800.927.2120 8am - 6pm EST

EASTON CLASSIC
Exposed Thermostatic System with 8" Shower Rose

Installation Guidelines

Page 2 of 3

Rev - 01


11.11.2013

These guidelines have been prepared for the professional contractor to aid in the installation of:
EASTON CLASSIC EXPOSED THERMOSTATIC SYSTEM WITH 8" SHOWER ROSE (STYLE No. EAXS42) &
EASTON CLASSIC EXPOSED THERMOSTATIC SYSTEM WITH 8" SHOWER ROSE AND HANDSHOWER
(STYLE No. EAXS52)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.

5. Turn on the water supply to flush out any debris

in the supply lines then turn them off.

6. Slide the escutcheons onto the nipples, making

sure to use the gasket provided. Hold the valve
up to the nipples and thread the union nuts onto
the nipples. Make sure to use the rubber washers
to create a proper seal and securely tighten.

7. Install the shower arm bracket using the

hardware provided. The bracket arm can be cut
to adjust the length. Make sure the set screw
creates a secure hold on the bracket arm.

8. Attached the shower arm to the valve body

using the rubber washer provided. Securely
tighten the union nut on the end of the shower
arm then secure the shower arm to the bracket
using the nuts and screw provided.

RUBBER

WASHER

UNION NUT

RUBBER

WASHER

UNION NUT

BRACKET

ARM

SET SCREW

MOUNTING

PLATE

ANCHOR

HEX KEY

SCREW

SET SCREW

ESCUTCHEON

BRACKET ARM

CAN BE CUT

SCREW

RETAINING

COLLAR

NUT

SHOWER

ARM

BRACKET

ARM

SET SCREW

MOUNTING

PLATE

ANCHOR

HEX KEY

SCREW

SET SCREW

ESCUTCHEON

BRACKET ARM

CAN BE CUT

SCREW

RETAINING

COLLAR

NUT

SHOWER

ARM


CALIBRATE THE TEMPERATURE:

¾ The risk of scalding exists until the installer has

properly calibrated the temperature setting.

9. Unthread the handle from the limit stop then

loosen the set screws to remove the limit stop
and expose the valve stem.


10. Turn on the water supply and integrated volume

control valve by rotating the handle
counterclockwise.

RUBBER WASHER

UNION NUT

SCREW

RETAINING

COLLAR

NUT

RUBBER WASHER

UNION NUT

SCREW

RETAINING

COLLAR

NUT

VALVE STEM

WASHER

VOLUME CONTROL

HANDLE

SET SCREW

LIMIT STOP

HANDLE

VALVE STEM

WASHER

VOLUME CONTROL

HANDLE

SET SCREW

LIMIT STOP

HANDLE