Waterworks R.W. Atlas Thermostatic Control Valve Trim with Metal Lever Handle - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
RW ATLAS
Thermostatic Control Valve Trim
INSTALLATION GUIDELINES
Page 1 of 3 8.9.2012
These guidelines have been prepared for the professional contractor to aid in the installation of:
RW ATLAS THERMOSTATIC CONTROL VALVE TRIM WITH METAL WHEEL HANDLE (STYLE#
RWTH01) & METAL LEVER HANDLE (STYLE # RWTH10)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
SEE SERVICE PART DOCUMENT FOR PART ORDERING, AVAILABLE ON WATERWORKS.COM
Metal Wheel Handle
Style No. RWTH01
Metal Lever Handle
Style No. RWTH10
SPECIFICATIONS:
Rough-In Depth when paired with Volume Control Valve:
GUVC16 (GUSV16) or GUVC17 (GUSV17):
2-1/2" MIN - 3-1/4" MAX
Rough-In Depth when paired with 2-Way Diverter
GUDV14 (GUSV14) & GUDV23 (GUSV23):
3-1/4" MIN - 4-1/4" MAX
REQUIRED PLUMBING DETAILS:
Universal 3/4" Thermostatic Valve
STYLE No. GUTH37
CODE No. GUSV37R
IMPORTANT:
¾ NOTE: The screws on the front of the trim plate and
on the front of the wheel handle are aesthetic only
and do not serve any mechanical purpose and
should not be removed.
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ This product is intended to work with the
Waterworks Universal Thermostatic Valve (STYLE #
GUTH37) which features anti-scald protection. The
risk of scalding exists until the installer has properly
calibrated/adjusted the temperature setting during
final trim installation. Refer to the Installation
Guidelines of the thermostatic valve for the rough-in
installation.
¾ Be sure your installation conforms to federal state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This thermostatic valve trim only mixes hot and cold
water. It does not have volume control or shut-off
capabilities. A diverter or wall valve (sold
separately) control on/off/volume and must be
installed for each fitting that will have water flowing
to it. This valve trim cannot be used directly with a
diverting tub spout.
¾ This product must be installed by a professional
licensed contractor and must be onsite prior to
rough-in, this allows the installer to visualize the
installation.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ DO NOT use putty on fittings.