Installation guidelines – Waterworks R.W. Atlas One Hole Bar Faucet, Metal Lever Handle User Manual

Page 2

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST

R.W. ATLAS
One Hole Bar Faucet with Metal Lever Handle

Installation Guidelines

Page 2 of 2

Rev - 01

10.31.2014

These guidelines have been prepared for the professional contractor to aid in the installation of:
R.W. ATLAS ONE HOLE BAR FAUCET WITH METAL LEVER HANDLE (STYLE No. RWKM30, RW30KM UK).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.

3. Re-install the RUBBER WASHER, METAL WASHER and

NUT. Securely tighten the NUT to secure the SPOUT to
mounting surface.

4. Connect the HOSES to the water supplies making sure

they are not pinched or kinked.

FINISH AND INSPECT THE INSTALLATION:

5. Remove the AERATOR from the SPOUT using a,

quarter sized, coin then open the hot and cold supplies
and carefully turn the HANDLE to flush out any debris
in the supply lines.

6. Inspect all connections for leaks.

7. Shut the water off and re-install the AERATOR.

SERVICING THE PRODUCT:



Refer to FIGURE – 02 for steps 8 & 9.

8. To remove the SPOUT, unthread the UNION NUT then

pull the SPOUT up to remove.

9. To access the CARTRIDGE, remove the HANDLE by

unthreading the GLAND COVER then unthread the
RETAINING COLLAR to expose the CARTRIDGE.

FIGURE - 02



If further assistance is required, please contact Product

Support at 1-800-927-2120 Ext 2 Monday through
Friday, 8am - 6pm EST.

RUBBER WASHER

RETAINING

COLLAR

UNION NUT

GLAND

COVER

SPOUT