Waterworks R.W. Atlas One Hole Bar Faucet, Metal Lever Handle - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
R.W. ATLAS
One Hole Bar Faucet with Metal Lever Handle Installation Guidelines
Page 1 of 2
Rev - 01
10.31.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
R.W. ATLAS ONE HOLE BAR FAUCET WITH METAL LEVER HANDLE (STYLE No. RWKM30, RW30KM UK).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
STYLE No. RWKM30†
SPECIFICATIONS:
Deck Thickness Maximum: 2-11/16” (68mm)
Fittings Hole Diameter: Ø1-3/8” (35mm)
Handle Turn Angle: Half Turn
Inlet Connection Size: 3/8”
Inlet Connection Type: Compression Connection Hoses†
Restricted Maximum Flow Rate: 2.2gpm (8.3liters/min)
Spout Reach: 6-11/16” (170mm)
Spout Swivel: No
Water Pressure Minimum: 20 psi (1.4 Bar)
Water Pressure Maximum: 80 psi (5.5 Bar)
Water Pressure Recommended: 45 psi (3 Bar)
† UK Style No.
RW30KM is supplied with 2 BSP adapters,
assembly required.
IMPORTANT:

To ensure this product is installed properly, you must
read and follow these guidelines.
 The owner/user of this product must keep this
information for future reference..
 This product must be installed by a professional
licensed contractor.

Be sure your installation conforms to all federal, state,
and local codes.
 In the State of Massachusetts, all installations must
comply with the rules and regulations set forth within
248 CMR.
 Refer to the specification and assembly drawings
attached. Product is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.
 Inspect the product to ensure you have all the parts
required for proper installation.

Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.

DO NOT use putty. Putty contains oil and can cause
permanent discoloration on certain materials such as
marble, granite and any porous surface.
INSTALLATION:
1. Remove the NUT, METAL WASHER, and RUBBER
WASHER from the THREADED ROD. See FIGURE - 01.
Do
NOT remove the O-RING beneath the
ESCUTCHEON.
FIGURE – 01
2. Ensure that the HOSES and THREADED ROD are
securely tightened to the VALVE BODY, then insert
the HOSES and THREADED ROD through the Ø1-3/8”
(35mm) hole on the mounting surface making sure the
O-RING is beneath the ESCUTHCEON.
 NOTE: The SPOUT must be installed with the HANDLE
on the right side of the SPOUT. The SPOUT cannot
swivel and the HANDLE rotates clockwise 180° to
open.
METAL WASHER
RUBBER WASHER
NUT
HOSE
THREADED ROD ESCUTCHEON
METAL WASHER
RUBBER WASHER
NUT
HOSE
THREADED ROD ESCUTCHEON