Waterworks Regulator Gooseneck Double Spout Marquee Kitchen Faucet, Metal Wheel Handles and Spray - Manual (Page 4)

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
REGULATOR
Gooseneck Double Spout Marquee Kitchen Faucet Installation Guidelines
Page 4 of 5
Rev - 01
10.9.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
REGULATOR GOOSENECK DOUBLE SPOUT MARQUEE KITCHEN FAUCET WITH METAL WHEEL HANDLES AND
SPRAY (STYLE No. RGKM50, RG50KM UK)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
FIGURE - 08
17. Connect the hot & cold HOSES to the corresponding
SUPPLY KITS (not supplied).
NOTE: The HOSES are marked with colored ZIP TIES
to identify their function.
Red for incoming hot supply
water and blue for incoming cold supply water.
18. Remove the AERATOR from both SPOUTS using the
TOOL provided then open the hot and cold supplies
and carefully turn the WHEEL HANDLES to flush out
any debris in the supply lines before operating the
SPRAY.
NOTE: Both SPOUTS can operate at the same time.
19. Inspect all connections for leaks.
20. Operate the LEVER HANDLE and ensure that a range
of temperatures exists.
21. With the RIGHT SPOUT on, operate the SPRAY to
ensure that water is being diverted properly. No water
should flow out of the RIGHT SPOUT while the SPRAY
is being operated.
NOTE: If the owner/user of this product wants the
LEFT SPOUT to diverter water to the SPRAY;
a. Make sure to turn off the water supplies during
this process.
b. Remove the PLUG from the HOSE with the
“yellow” ZIP TIE on the LEFT SPOUT.
c. Attach the PLUG to the HOSE with the “yellow”
ZIP TIE on the RIGHT SPOUT.
d. Repeat step 15, this time connecting the HOSE
with the “yellow” ZIP TIE from the LEFT SPOUT
to the TEE.
22. Shut the water off and re-install the AERATORS.
SERVICING THE SPOUT(S):
1. To remove the SPOUT, unthread the NUT to expose
the SET SCREWS on the front and back of the SPOUT
VALVE BODY. See FIGURE – 09.
SUPPLY KIT
(NOT SUPPLIED)
RUBBER WASHER
ADAPTER
FIBER WASHER
CHECK VALVE
HOUSING
SUPPLY KIT
(NOT SUPPLIED)
RUBBER WASHER
ADAPTER
FIBER WASHER
CHECK VALVE
HOUSING 2. Loosen the SET SCREWS and pull the SPOUT up to
remove as shown in FIGURE – 09.
FIGURE - 09
SERVICING THE SHUT-OFF CARTRIDGE(S):
1. To access the SHUT-OFF CARTRIDGE, unthread the
SCREW then remove the HEX COLLAR, METAL
WASHER, WHEEL HANDLE, and HANDLE STEM as
shown in FIGURE – 10.
2. Unthread the GLAND COVER to expose the
SHUT-OFF CARTRIDGE as shown in FIGURE – 10.
FIGURE - 10
SET SCREW
NUT
SET SCREW
NUT
SHUT-OFF
CARTRIDGE
GLAND
COVER
HANDLE
STEM
WHEEL
HANDLE
METAL
WASHER
HEX
COLLAR
SCREW
SHUT-OFF
CARTRIDGE
GLAND
COVER
HANDLE
STEM
WHEEL
HANDLE
METAL
WASHER
HEX
COLLAR
SCREW