Waterworks R.W. Atlas Low Profile Three Hole Wall Mounted Lavatory Faucet with Metal Lever Handles - Manual (Page 2)

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
RW ATLAS
Wall Mounted Lavatory Faucet
INSTALLATION GUIDELINES
Page 2 of 3 8.9.2012
These guidelines have been prepared for the professional contractor to aid in the installation of:
RW ATLAS WALL MOUNTED LAVATORY WITH METAL WHEEL HANDLES (STYLE# RWLS60) &
METAL LEVER HANDLES (STYLE # RWLS70)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
SEE SERVICE PART DOCUMENT FOR PART ORDERING, AVAILABLE ON WATERWORKS.COM
Figure - 01
1
2 " MALE X 1
2 " SWEAT
ADAPTER (NOT SUPPLIED)
VALVE BODY
1
2
" COPPER PIPE
(NOT SUPPLIED)
1
2
" COPPER PIPE
SUPPLY LINE
(NOT SUPPLIED)
1
2
" COPPER
COUPLER
(NOT SUPPLIED)
SOLDER
1
2
" NIPPLE
(NOT SUPPLIED)
SPOUT INSTALLATION:
¾ See Figure - 02 for steps 7 - 9
7. After the finished wall is complete, thread a 1/2" NPT
brass nipple (not supplied) of appropriate length
into the valve tee.
8. Wrap the nipple with Teflon tape and thread on the
spout, making sure the o-ring is behind the
escutcheon. Tighten the spout and make sure it is
oriented correctly. Note: The octagon collar is
aesthetic only and is not to be used to tighten the
spout.
9. If there is a gap between the wall and the
escutcheon, the escutcheon can be unthreaded to
contact the wall and the octagon collar can slide
back to make up the difference.
Figure - 02
AERATOR
FINISHED WALL
SPOUT
HANDLE INSTALLATION:
¾ See Figure - 03 for steps 9 & 10
10. After spout has been secured, mark the handle
sleeves at the finished wall. Unthread the sleeves
and cut 1/2" behind the mark.
11. Mark the cartridge stems at the wall, then unthread
the cartridge from the valve body. Cut the cartridge
stems 1/4" in front of the mark.
12. After the cuts have been made, thread cartridge and
handles sleeves back onto valve body.
Figure - 03
FINISHED WALL
1
2 "
[13mm]
1
4 "
[6mm]
CUT SLEEVE
CUT STEM
¾ See Figure - 04 for steps 12 & 13
13. Thread the trim nuts to the handle sleeves until they
stop at the finished wall.
14. Install handle assembly by threading it into the trim
adapter, making sure the o-ring is behind the
escutcheon. Use the handle's knurled piece to get a
good grip.
Figure - 04
AERATOR
TRIM ADAPTER
HANDLE O-RING
HANDLE ASSEMBLY
FINISHED WALL