Casio CW-L300 User Manual
Page 58
E
56
10.
Use
and
to select the print area you want to print, and then press
SET.
11.
Insert a disc into the printer.
12.
Press SET to start printing.
• Both DATA 1 and DATA 2 print in both the upper print area and
the lower print area of the disc.
13.
After printing is complete, use
and
to select EXIT, and then press
SET.
14.
In response to the confirmation message that appears, press SET.
■ To perform tape demo printing
1.
Make sure a tape cartridge is loaded in the printer.
• See page 13 for the Startup Guide for information about loading tape
cartridges.
2.
If the printer is on, press
to turn it off.
3.
Press
to turn on the printer.
4.
Press FUNCTION and then SET UP.
5.
Use
and
to select DEMO PRINT, and then press SET.
6.
Use
and
to select TAPE, and then press SET.
7.
Use
and
to select PRINT, and then press SET.
8.
Confirm that 1 is specified for the number of copies and CONT HALF CUT
is specified for the tape cut mode.
• You can change the number of copies and the tape cut mode (page 38)
settings if you want.
• If you are using a non-standard type of tape, select the appropriate tape
cut mode (page 38) for the tape you are using.
9.
Press SET to start printing.
• The demo print contents depend on the width of the tape cartridge
currently loaded in the printer.
10.
After printing is complete, use
and
to select EXIT, and then press
SET.
11.
In response to the confirmation message that appears, press SET.