Compaq 8000 User Manual

Page 129

Getting Started

8–13

Upgrading the PC

To Replace or Add a Drive

1. Install four guide screws on the sides of the

drive (two on each side). The screws help
guide the drive into its proper position in the
bay.
❏ When replacing a drive on either the S and

8000 series, place the screws that you
removed from the old drive in the new
drive.

❏ When adding a second hard disk drive on

the 8000 series, use the four extra guide
screws that are attached to the chassis
under the front bezel.

2. Slide the drive into the drive bay

1, making

sure to align the guide screws with the guide
slots, until it snaps into place.

Sliding the drive into the drive bay on the S/8000
(S shown)

3. Reconnect the power and data cables to your

drive as indicated in the following illustrations.