Weiser SmartCode Lever - Manual (Page 8)

8
ON
1
2
3
4
11. SmartCode User Selectable Settings.
Switch #2 Enables the AUTO LOCK
when in the ON position. With Auto Lock en-
abled, SmartCode will automatically relock the
door 30 seconds after unlocking.
Switch #1 Status LED blinks every
5 seconds when in the ON position. Note:
The low battery RED LED cannot be
disabled.
Switch
Position
OFF
ON
LED
Color
Green
Orange
Red
Unlocked
Locked
Low Battery
Lock
Status
Red Low Battery
Hint: for easier access, use a ball point pen to operate the switches.
Switch #4 Extra switch with NO FUNCTION.
Switch #3 Enables the AUDIO sound (Beeper) when in the ON
position. Keypad will now light red/green when buttons are pressed.
a. Press the program button on the interior unit four times.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the “LOCK” button to save code.
d.
a. Press the program button on the interior unit three times.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the “LOCK” button to save code.
d.
Press the “LOCK” button and re-enter the code to test. Unit should go
to the unlocked position allowing exterior lever to retract the latch. If it
does not go to the unlock position, repeat steps (a) through (c).
Press the “LOCK” button and re-enter the code to test. Unit should go
to the unlocked position allowing exterior lever to retract the latch. If it
does not go to the unlock position, repeat steps (a) through (c).
Programming the 4th user code.
Programming the 3rd user code.
CAUTION: Prevent unauthorized entry. This lock can be opened using four
different codes that are randomly set at the factory. Upon installation and set-up,
replace all of these codes with your own. Since anyone with access to the power
board can change these codes, you must restrict access to the power board and
routinely check both codes to assure they have not been altered without your
knowledge.
10. Continued.....
LED
Switches