Weiser SmartCode Lever - Manual (Page 2)

2
2-3/8" (60mm) or
2-3/4" (70mm)
1. Install latch and Strike.
Fig. 1
Fig. 2
d. Install strike plate onto door jamb using two small screws. Minor loose
door fit may be reduced by adjusting tang. Note, the lock will not lock prop-
erly if the smaller bolt of latch enters the strike hole. Reposition strike plate if
required.
a. Determine your backset, see figure 1.
b. If backset measured 2-3/4” (70mm), adjust latch as
follows: Using fingers, grasp the spring pin and move
it down and over to the 2-3/4” (70mm) slot. (See
figure 2).
For a drive in latch:
Align collar opening with
shape of bolt and slide it
on until the catch pins of
latch snap into the pin holes
of collar. Install latch with the
slant of bolt facing in the direction that the door closes. Use wood block to
install latch. Note, should collar require removal, squeeze collar hard at
sides and remove.
For a latch with face plate:
(1) Insert latch into backplate,
(2) Insert latch and
backplate into door with
the slant of bolt facing in
the direction that the door closes.
(3) Place desired face plate over backplate and fasten
with two small screws.
c. Prepare latch.
Face plate
Spring
Pin
Backplate
Catch Pin
Tang
Small
Bolt
Pin
hole
Collar