Mercedes-Benz CL-Class 2014 COMAND Manual - Manual (Page 228)

Switching modes via the audio menu
When you connect an external audio source,
audio AUX is not selected automatically.
X Select Audio in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
If AUX mode was the last mode selected, it
will now be active.
If another audio source is switched on, you
can now switch to audio AUX mode in the
audio menu.
X Select Audio using ZV and press W to
confirm.
The audio menu appears.
X Select Aux using cVd and press W to
confirm.
The audio AUX menu appears. The medium
in the external audio source is played if the
source is connected and playback
selected.
Please see the respective operating
instructions for how to operate the external
audio source.
Information on:
R Volume settings (
Y
page 29)
R Sound settings (
Y
page 30)
Increasing the volume on COMAND
X Select Volume in the AUX display by turning
cVd the COMAND controller and press
W to confirm.
A menu appears. The # dot indicates the
current setting.
X Select Standard or Boost and press W to
confirm.
Standard : the volume of the external audio
source is adjusted to a standard value.
Boost : the volume of the external audio
source is raised by approximately 10 dB.
A device which is connected as an external
audio source may seem quieter or louder in
the vehicle, or the usual maximum volume
cannot be achieved. On some devices, it is
possible to adjust the volume separately. In
this case, start at a medium volume and
increase it gradually. This enables you to
determine whether the system is able to play
the music at high volume without distorting
it.
226
Audio AUX mode
Audio