Navigation, Additional settings – Mercedes-Benz CL-Class 2014 COMAND Manual User Manual
Page 117
The calculated route may include an area to
be avoided if:
R
your destination is located in such an area.
R
the route uses roads that lead through an
area to be avoided.
i
Highways within blocked areas are always
taken into consideration in the route
calculation.
Defining an area for the first time
Calling up the area menu
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select
Navi
in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X
Select
Avoid Area
and press W to
confirm.
If you have not previously blocked an area,
a menu appears.
X
Select
Using Map
,
From Memory
or
From
Personal POIs
and press W to confirm.
If you select
Using Map
, the map with the
crosshair appears.
If you select
From Memory
or
From
Personal POIs
, either the destination
memory or the list of categories for POIs
appears.
R
Destination memory (
Y
page 70)
R
List of categories for personal POIs
(
Y
page 85)
X
Select the desired destination or personal
POI and press W to confirm.
X
When the destination address is displayed,
select
Cont.
and press W to confirm.
The map appears.
The crosshair marks the center of the area
that is to be avoided.
X
To scroll the weather map: slide XVY,
ZVÆ or aVb the COMAND controller.
X
To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears. Turning clockwise zooms out from
the map; turning counter-clockwise zooms
in.
X
Turn cVd until the desired scale is set.
X
To apply a block: press W the COMAND
controller.
A red square appears on the map.
X
To adjust the size of the square: turn
cVd the COMAND controller.
The square is enlarged or reduced.
X
To confirm the settings: press W.
The list appears. The previously selected
area to be avoided has been added and
activated.
You can also determine additional areas to be
avoided (
Y
page 116).
Additional settings
115
Navigation
Z