Kontron AM4024e User Manual
User guide
This manual is related to the following products:
Table of contents
Document Outline
- Revision History
- Imprint
- Disclaimer
- Warranty
- Proprietary Note
- Trademarks
- Environmental Protection Statement
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Functional Description
- 3 Configuration
- 3.1 DIP Switch Configuration
- 3.2 System Write Protection
- 3.3 AM4024(E)-Specific Registers
- 3.3.1 Write Protection Register (WPROT)
- 3.3.2 Reset Status Register (RSTAT)
- 3.3.3 Board ID High-Byte Register (BIDH)
- 3.3.4 Geographic Addressing Register (GEOAD)
- 3.3.5 Watchdog Timer Control Register (WTIM)
- 3.3.6 Board ID Low-Byte Register (BIDL)
- 3.3.7 LED Configuration Register (LCFG)
- 3.3.8 LED Control Register (LCTRL)
- 3.3.9 General Purpose Output Register (GPOUT)
- 4 Power Considerations
- 5 Thermal Considerations
- 6 SATA Flash Module
- 7 RTC Backup Battery Module
- 8 Installation
- 9 uEFI BIOS
- 10 IPMI Firmware
- 10.1 Overview
- 10.2 IPMI Firmware and KCS Interface Configuration
- 10.3 Supported IPMI and ATCA Commands
- 10.4 Firmware Identification
- 10.5 Board Control Extensions
- 10.6 Sensors Implemented on the AM4024(E)
- 10.7 Sensor Thresholds
- 10.8 OEM Event/Reading Types
- 10.9 IPMI Firmware Code
- 10.10 LAN Functions
- 10.11 E-Keying