4 usb client interface – Kontron pITX-SP User Manual
Page 23
KTD-S0002-I
Page 18
USB Interface
p
ITX-SP User's Guide
7.4
USB Client Interface
Following steps are necessary to prepare a connection:
Invoke the BIOS Setup and set Advanced/Onboard Device Configuration/USB Configuration/
USB Client Controller to Enabled.
Use
following
cable
wiring.
Pin pITX-SP (J3303)
Pin Host Computer
Comment
1
1
GND
3
2
USB-
2
3
USB+
4
---
Don't connect these pin
Use USB_Client.zip, start Setup.exe from the directory XPPro and install the client software on
the pITX-SP. For more information see the including documentation USBC_ReleaseNotes.pdf.
Use USB_Client.zip, start Setup.exe from the directory XPPro/hostwizard and install the host
software on the host computer.
The only operating mode which is approved by KONTRON is RNDIS-only mode.
- CP3003-SA uEFI BIOS (72 pages)
- CP3003-SA (36 pages)
- CP3002 (38 pages)
- CP3002-RC uEFI (64 pages)
- CP-RIO3-05 (42 pages)
- CP3002-RC (30 pages)
- CP342 (52 pages)
- CP930 (46 pages)
- CP932 (52 pages)
- CP346 (72 pages)
- CP384 (66 pages)
- CP383 (74 pages)
- CP382 (58 pages)
- CP381 (60 pages)
- CP372 (64 pages)
- CP371 (60 pages)
- CP-RIO3-04S (38 pages)
- CP390 (36 pages)
- CPS3410 (9 pages)
- CPS3402 (9 pages)
- CPS3105 (9 pages)
- CPS3101 (9 pages)
- CPS3003-SA (19 pages)
- PB-SIO4 (34 pages)
- PB-SIO4A (34 pages)
- PB-DOUT8 (34 pages)
- VMOD-2 (82 pages)
- VSBC-32 (110 pages)
- VM42 (62 pages)
- Bootstrap Loader (24 pages)
- VMP1 with Netbootloader (120 pages)
- VMP1 (106 pages)
- NetBootLoader (86 pages)
- VMP2 (142 pages)
- VMP3 (154 pages)
- CP-RIO6-923 (32 pages)
- CP-RIO6-923-F (32 pages)
- CP-RIO6-001 (28 pages)
- CP-RIO6-001-HD-VGA (46 pages)
- CP-RIO6-M (20 pages)
- CP-RIO6-B (28 pages)
- CP6925 (42 pages)
- CP6002 uEFI BIOS (76 pages)
- CP6002 IPMI (40 pages)
- CP6002 (42 pages)