7 backlight connector, 8 display default settings, Pitx-sp user's guide – Kontron pITX-SP User Manual

Page 21

background image

KTD-S0002-I Page

16

Graphics

Interface

p

ITX-SP User's Guide

6.7

Backlight Connector

Backlight is available through the J1801 connector (7 pins). An external voltage source must be used to
supply the backlight with +5V or +12V.

Header

Pin

Signal Name

Function

1

N.C.

Not connected

2

BKLTADJ

Brightness control (0V - +5V)

3

GND

Ground

4

N.C.

Not connected

5

N.C.

Not connected

6

GND

Ground

1

7

7

BKLTON

Backlight on/off

6.8

Display Default Settings

On the first boot-up a DVI monitor must be connected to the pITX-SP. The simultaneous mode is not sup-
ported by Intel

®

. During the boot process respectively DOS mode the VGA BIOS only allows a DVI monitor or

a flat panel.

See also other documents in the category Kontron Hardware: