beautypg.com

Vmod-2/vmod-2d, Product overview – Kontron VMOD-2D User Manual

Page 15

background image

VMOD-2/VMOD-2D

12/15/97

Product Overview

Page 1 - 5

Man. ID 03139, Rev. Index 0200

1.5 VMOD-2 Specifications

Table 1-3: VMOD-2 Specifications

VMOD-2

Specification

External Interface

50-way flat band cable connector (upper half and
lower half used by respective piggyback position)
only accessible via the addition of VMOD/VMOD-2
piggyback (s) to the desired interface standard

VMEbus Interface

A24:D8/16, A16:D8/16 Slave

VME Address Range

Occupies 256 Bytes or 8 KBytes, A1....A11 to each
piggyback. Base Address jumper selectable.

Interrupt Requester

Single-level , IRQ 1-7. Jumper selectable. Two
lines for interrupt request, one per Piggyback. Inter-
rupt vector generated by piggybacks, or by jumper
settings on VMOD-2.

External Reset Inputs

Pins 25 and 26 of front-panel connector may be
used to connect a NC (Normally closed) push-but-
ton reset switch, or for the creation of an "Emer-
gency-Stop" loop, or for automatic detection of
disconnection of interface. This facility may be dis-
abled via jumper setting.

Power Requirements

+5V DC (± 5%), 140 mA, excluding additional piggy-
backs demands

Temperature Range
- Operating

- Storage

- 0° to +70° C (standard)
- -40° to +85° C (extended, subject to fitted piggy-
back/-s)
- -55° to +85° C

Operating Humidity

5 - 95% (non-condensing)

Board Size

Single-height Eurocard 100 x 160 mm (4 x 61/4")

VMOD to Piggyback
Connectors (VME
side)

A triple-row (to/from VMOD's VME side) per piggy-
back location. Providing Address, Data and neces-
sary control line interfaces to selected PB type(s)
fitted.

This manual is related to the following products: