Elecraft KRX3 - Manual (Page 24)

24
Locate the four coaxial TMP cables supplied and sort them by length. There are two 5” (13 cm) one 10” (25
cm) and one 12” (30 cm) cables. These are approximate measurements measured from the tip of one connector
to the other. Check the cables as shown in Figure 27 to ensure there are no excess strands of the center
conductor extending beyond the tip of the connector. .
Figure 27. TMP Cable Connectors.
CAUTION
When inserting or removing the TMP connectors, always use the grip as shown in
Figure 27. Pulling on the black cable may rip it out of the connector.
Plug one end of the 10” (25 cm) cable into J84 near the bottom of the auxiliary KSYN3 synthesizer board.
The other end of the cable will be connected later.