Installing the early style deck on the 4wd dyno – Dynojet 424x: Installation Guide User Manual
Page 163
S T A T I O N A R Y D Y N O U P G R A D E
Deck Relocation
Version 8
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C-11
I
NSTALLING
THE
E
ARLY
S
TYLE
D
ECK
ON
THE
4WD D
YNO
Before installing the deck, make sure to complete the 4WD dyno and bridge
installation found in Chapter 3 along with the optional eddy current brake installation
found in Chapter 4.
The deck mounting holes must be modified before the early style deck can be
mounted to the 4WD dyno.
1
For the two outer holes, mark each hole .5-inches up from the existing hole and
.5-inches towards the outside of the deck.
2
Drill the new holes 7/16-inch (10 mm).
3
For the three inner holes, mark each hole .5-inches up from the existing hole.
4
Drill the new holes 7/16-inch (10 mm).
Figure C-10: Modify the Deck Mounting Holes
AD106
.5 in.
new hole
outer existing hole shown
with new hole marked
.5 in.
.5 in.
.5 in.
.5 in.
outer existing hole shown
with new hole marked
new hole
outer existing hole shown
with new hole marked
new hole