Craftsman 113.299210 - Manual (Page 42)

Blade Elevation
W hen the etevatjon handw hee! is turned ciockwise, uniii
It stops, the blade m ust not be m ore that 2^5/8 inches
above the table it the blade extends m ore than 2-5/8
inches, the m otor could interfere with the underside of the
table causing m isalignm ent.
W ith the blade extending 2-5/8 inches above the table,
the stop coilar and spacer m ust be against the eievation
screw pivot nut If the blade extends m ore that 2-5/8
inches, loosen tw o screw s in stop collar, and readjust it.
Adjustments (continued) —
Tilt and Elevation Mechanism
The handw heels should turn freely w ithout binding, The
turning action can be adjusted by tightening or loosening
the screws in the bearing retainer Both handw heels
m ust be rem oved to reach the adjusting screws
N O TE; W hen adjusting the screw s on the lilt bearing
rstainsr, hold the nut inside using a 3/8" w rench, The
screw s for fhe eievation bearing retainer can be reached
w ith a sm all screw driver through the curved slot on the
front of the saw
Tilt
Handwheel
42