Craftsman 113.299210 - Manual (Page 19)

Installing Blade Guard
1 From the bag iabeled “Guard" remove the following
hardware;
*2 Truss Head Screws, 1/4-20 x 5/8" Long
*2 Socket Head Set Screws, 1/4-20 x 7/8" Long
•■4 Flat washers. 17/64 x 9/16 x 3/64
*2 Hex Nuts 1/4-20
*4 Lockwashers, 1/4 External Type
*2 Wing Nuts, 1/4-20
*2 Square Nuts, 1/4-20
1 Spreader Support
1 Spreader Bracket
1 Spreader Clamp
From amortg the loose parts find the following:
1 Blade Guard
Hems marked with asterisk (*) are shown actual size
1/4-20 X 5/S In.
Truss Head Screw
1/4-20 X7/S
Socket Head
Set Screw 1/4 In. External
Lockwasher
o
1/4-20
1/4-20 Hex Nut Square Nut
17/64 I D. 1/4-20 Wing Nut
Flat Washer
Spreader Support Spreader Clamp
Spreader Bracket
2 Make sure the blade Is all the way up and square with
table,
3, Position spreader support on rod until it is even with
the end of the rod.
4 Assemble the 7/8 Inch long set screws, nuts, lock-
washers and washers to the spreader support bracket
and slip the nuts into the slot in the spreader support
5 Finger tighten only the hex nuts
NOTE: Be sure to put the socket head set screw through
the slot shaped holes in the spreader bracket (see illus­
tration). This allows the guard and spreader to be lined
up with the blade Be sure the socket end of the set
screw is at the hex nut end of the assembly.
19