Flipping (continued), Basic saw operations (continued) – Craftsman 113.299210 User Manual

Page 32

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Basic Saw Operations (continued)

flipping (continued)

Once the traiiing end is on the table:

When “width ol rip" is 2" or wider, use the push stick to
finish pushing the work all the way past the blade

When “width of rip" is narrower than 2" the push stick
cannot be used because the guard will interfere, use the

auxiliary fence and push block.

Attach auxiliary fence to rip fence with two “C” clamps

Guard

Auxiliary

Fence

Feed the workpiece by hand along the auxiliary fence
until the end is approximately 1" past the front edge of the

table Continue to feed using the push block.

Hold the workpiece in position and install the push block
by sliding it on top of the auxiliary fence (this may raise
guard)