Craftsman 113.299210 - Manual (Page 14)

Assembling Table Extensions
1 From the bag labeled “Table Extensions” remove the
following hardware: (Quantity indicated is for two
extensions)
*8 Hex Head Screws, 5/16-18x1 -1/4” Long
*8 Fiat Washers. 21/64 x 5/8 x 1/16
*8 Lockwashers. 5/16" External Type
*8 Hex Nuts, 5/16-18
*10 Truss Head Screw, 1/4-20 x 1
*10 Hex Nut, 1/4-20
*10 Lockwashers, 1/4 External Type
*4 Flat Washers, 1/7/64 x 3/4 x 1/16
2 Brackets
From the bag labeled “Large Parts” remove only the fol­
lowing:
4 Comer Support Brackets
From among the loose parts find the following:
2 Table Extensions
Items marked with asterisk (*) are shown actual size
Assembly (continued)
2 Assemble with saw upside down
NOTE: To protect the finished surfaces of the saw and
extensions, lay a piece of heavy paper or cardboard on
the floor.
WARMING: Stock table extensions must be
installed. They help support the fence guide bars.
An unsupported guide bar can twist. Twisted
guide bars can misalign fence. A misaligned fence
can cause binding or kickback. You could be hit or
cut.
3 Install corner support brackets, 1/4-20 x 1 inch truss
head screws, 17/64 inch flat washers, 1/4 inch exter­
nal lockwashers and 1/4-20 hex nuts as shown, Hand
tighten only
Insert four (4) 5/16-18 x 1-1/4 inch long hex head
screws through the holes on inside edge of one
extension
install 21/64 I D fiat washer, 5/16 external lock-
washer, and 5/16-18 hex nut on the end of each
screw Just start nut on end of screw
Slide the extension with hardware into tour slots in
side of table. Line up front edge of extension with
front edge of table and tighten all screws and nuts
Repeat for other extension
B
bhhi
(Q)
LI5/16-18x1-1/4 In Vli/
Hex Head Screw
Q
5/16?l8
Hex Nut
21/64 LD.
Flat Washer
X----- -X 1/4-20
17/64 LD, Hex Nut
Flat Washer
B/16 In External
Lockwasher
1/4 In External
Lockwasher
1/4-20 X 1 In
Truss Head Screw
Bracket
14