Craftsman 113.299210 - Manual (Page 13)

Mounting Your Saw need picture
“Base" remove the following 1 From the bag labeled
hardware:
”4 Hex Head Screws, 5/16-18 x 1 -1/8'* Long
*4 Hex Nuts, 5/16-18
*4 Lockwashers, 5/16" External Type
*8 Flat Washers, 11/32
X
11/16
X
1/16
items marked with asterisk C) are shown actual size
2 Place the saw upside down onto a smooth piece of
cardboard or heavy paper, on the floor, so the saw Is
resting on the table top
WARNING: The saw is heavy. To avoid back injury,
get help to lift the saw. Hold the saw close to your
body* Bend your knees so you can lift with your
legs, not your back.________________________
3. Place legs on saw so that holes in saw base and leg
set line up and trim label is facing front* Legs will over­
hang base in rear
4, install screw, washers, lockwasher and nut as shown
5 Tighten all leg assembly and mounting hardware at
this time
NOTE: For clarity, later manual illustrations may not
show leg set attached-
Bench Mounting
If you do not use the legset and prefer to mount the saw
on a bench, make sure that there is an opening in the top
of the bench the same size as the opening in the bottom
of the saw so that the sawdust can drop through. Recom­
mended working height is 33 to 37 inches from the top of
the saw table to the floor
5/16-18 X 1-1/8 In
Hex Head Screw
S/16 In External
Lockwasher
5/16-18
Hex Nut
@
11/32 I.D.
Flat Washer
13