Craftsman 113.299210 - Manual (Page 21)

Getting to Know Your Table Saw
1. On-Off Switch.
CAUTION: Before turning switch “ON”, make sure
the blade guard is correctly installed and operat­
ing properly.______________________________
The On-Oft Switch has a locking feature. This feature is
intended to help prevent unauthorized and possible haz­
ardous use by children and others
A Remove key from bag labeled ''Miscellaneous” and
Insert into swHch,
B. To turn saw ON, stand to either side of the blade,
never in line with it, insert finger under switch lever
and pulì end of lever out
After turning switch ON, always allow the blade to
come up to full speed before cutting. Do not cycle
the motor switch on and off rapidly, as this may
cause the sawblade to loosen. In the event this
should ever occur, allow the sawblade to come to a
complete stop ar\d retighten the arbor nut normally,
not excessively. Never leave the saw white the
power is “ON"
C. To turn saw OFF, PUSH lever in Never leave the
saw until the cutting too! has corns to a complete
stop
D To lock switch in OFF position, hoid switch IN with
one hand, REMOVE key with other hand
WARNINGS: For your own safety, lower blade or
other cutting tool below table surface. (If blade is
tilted, return it to vertical, 90“, position.) Always
lock the switch “OFF”. When saw is not in use,
remove key and keep it in a safe place. Also, in the
event of a power failure (all of your lights go out)
turn switch off, lock it and remove the key. This
will prevent the saw from starting up again when
the power comes back on.
21