Craftsman 113.299210 - Manual (Page 41)

5. if blade is not square to table, the 90° lim it stop m ust
bs cidjustGci
CAUTfON: Cover blade with piece of cardboard to
protect your hand.
A Using a sm all size screw driver, reach underneath
saw and loosen both set screw s in 90° stop collar.
N O TE: It you can't reach the set screw s turn the liH
handw heel slightly
B Rotate the stop collar m oving it aw ay from pivot nut.
C Tilt blade right or left, checking w ith your square until
blade is square to table,
D . R otate stop collar tow ard pivot nut until it touches
the pivot nut. Tighten the set screws,
E Check pointer, if it does not point to the "0" m ark on
the bevel scale bend pointer to read “0".
6, Tilt blade to left as far as It w ill go it w ill stop when the
pivot nut is against the 45° stop collar
7. Place an accurate square against blade, M ake sure
square is not touching the tip of one of the saw teeth
8, If blade is not 46° to table, the 45° stop collar m ust be
adjusted
A. R em ove elevation handw heel
B, U sing a sm all size screw driver, reach through
curved slot in front trim pane! and loosen both set­
screw s in 45“ stop collar
N O TE: if you can’t reach the setscrew s, turn the tilt
handw heel slightly
C R otate the stop collar m oving it in or out and tilt
blade right or left, checking w ith your square, until
blade is 45° to table
D Tighten the setscrew s
N O TE: If you can’t reach Ihs setscrew s, turn the tilt
handw heel slightly
E Reinstall elevation handwheel
41