Ássembiy (continued), Checking table insert, C hecking table insert – Craftsman 113.299210 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Text mode
Original mode

Ássembiy (continued)

Checking Table Insert

The table insert must be flush with the surface of the saw
table to keep the workpiece from hanging up or binding
with the sawbiade as the workpiece is cut by the saw-
blade.

1 Lower sawbiade beneath the table insert and check to

be sure the screw fastening the insert in place is snug,

2 Use a straight edge to check near each ot the eight

leveling tab positions to determine if the insert is flush
with the surface of the saw table at ail eight leveling
tab positions

3, If insert is not fiush with table surface, loosen insert

fastening screw and pull insert forward to lift from saw

table.

4 Bend with pliers or tap with a hammer, as required, to

make the insert flush with the table top.

Leveling