Craftsman 113.299210 - Manual (Page 12)

Assembly
Installing Handwheels and Bevel Pointer
1. From the bag labeled "Miscellaneous'' remove only the
following hardware:
"2 Pan Head Screws, 10 ~ 32 X 5/8" Long
*2 Lockwashers, #10 External Type
*1 Pan Head Screw Type “T' 8-32 x 3/8 Long
1 Bevel Pointer
From the bag labeled “Large Paris” remove only the
following:
2 Handwheels
Items marked with asterisk {*) are shown actual size
2, Fasten bevel pointer to cradle assembly with 8-32 x 3/8
screw, as shown. Adjustment of the pointer may be nec­
essary later
3 Line up flat spots on shaft and handwheel, push
handwheel onto shaft Install screw and iockwasher to
lock handwheel on shaft Repeat for the other hand­
wheel
QMK)
10-32x5/8 In.
Pan Head Screw
Bevel Pointer
Osas®
Type "T" 8-32 X 3/8 In.
Pan Head Screw
Handwheel
#10 External
Lockwasher
Assembling Steel Legs
1 From the bag labeled “Legs" remove the following
hardware:
*16 Truss Head Screws, 1/4-20 x 1/2” long
*16 Lockwashers, 1/4" External Type
*16 Hex Nuts, 1/4-20
*8 Hex Nuts, 3/8-16
4 Leveling Feet
From among the loose parts find the following:
4 Legs
2 End Stiffeners
2 Side Stiffeners
Items marked with asterisk (*J are shown actual size
2 Assemble the legs as shown
Insert the truss head screws through the holes in the
legs, then through the holes in the side and end stiffen­
ers-
Legs must be assembled on top of stiffeners
Install the lockwashers Screw on the nuts hand tight
install leveling feet through holes in bottom of legs as
shown.
Adjust leveling feet as follows:
a Move saw to desired location ,
b With 9/16" wrench loosen bottom nut
c. Back off top nut by hand
d Raise or lower toot by adjusting bottom nut using
9/16" wrench-.
e, Snug fop nut against irrstde of leg by hand,
f. Tighten all four bottom nuts using 9/16” wrench
1/4 In. External 1/4-20
ru”H»d'lc;.w Lockw^shT H„Nu.
3/8 -16 Hex Nut
Leveling Foot
Leg
3
4
Leveling Foot - 4
12