Craftsman 113.299210 - Manual (Page 16)

3 Mount switch to front guide bar with two 5/16-18 x 3/4
hex head screws, four iockwashers and two nuts,
Securely tighten both nuts
Assembly (continued) ----------
Hex Nuts
Hex Head Screws
4 Place front guide bar against saw table and drop it in
place engaging the screws in the slots Make sure the
spacers are between the Iront guide bar and the
table
5- End ot front guide bar must be 7-5/16 inch from side
of saw table. This is important so that rip fence indi­
cator can be aligned
6 With the blade of your combination square set to 1/4
inch, gauge and adjust front guide bar so the edge of
the bar is 1/4 inch above the edge ot the table.
Securely tighten nuts
7, Install 5/16-18
X
1-1/2 hex head screw through the
fourth slot in front guide bar (that lines up with
bracket), through the 1/4 inch spacer and the bracket.
Install a 5/16 inch external lockwasher and 5/16-18
hex jam nut.
10
11
Remove Ihe two truss head screws from rear of right
table extension.
Attach the rear guide bar in a similar manner to the
front guide bar Make sure that the end of the bar is
11 inches from the side of Ihe saw table. Spacers are
not required
Reinstall two truss head screws, Iockwashers and
hex nuts removed in step 8. Check that all hardware
is tight.
Insert 5/16-18
X
1 hex head screw through the eighth
slot in rear guide bar and bracket. Install 5/16 exter­
nal lockwasher and 5/16 hex jam nul Tighten
securely.
16