Thermcraft XST-3-0-36-3V - Manual (Page 98)

Programmer Operation Installation and Operation Handbook
5-16 2408 and 2404 Controller
Power Value [End Segment]
Use
or to set the power value in the range ±100.0%.
This power level is clipped by the parameters ‘ OP.Hi’ and
‘ OP.Lo’ before being applied to the process.
Note: In programmer/controller software versions 3.56
onwards this parameter has been replaced by a parameter
End.P which appears at the end of the Output List, see
Chapter 2
Press
to return to the ProG-LiSt header.