Thermcraft XST-3-0-36-3V - Manual (Page 193)

Installation and Operation Handbook Operation
2416 Controller 2-9
2.4.2 Parameter names
In the navigation diagram, (Fig2-6) each box depicts the display for a selected parameter.
The upper readout shows the name of the parameter and the lower readout its value.
The Operator parameter tables later in this chapter list all the parameter names and their
meaning.
The navigation diagram shows all the parameters that can, potentially, be present in the
controller. In practice, only those associated with a particular configuration will appear.
The shaded boxes in the diagram indicate parameters that are hidden in normal operation. To
see all the available parameters, you must select Full access level. For more information
about this, see Chapter 3, Access Levels.
2.4.3 Parameter displays
Figure 2-5 Typical parameter display
Parameter displays show the controller’s current settings. The layout of parameter displays is
always the same: the upper readout shows the parameter name and the lower readout its value.
Alterable parameters can be changed using or . In the above example, the parameter
mnemonic is
1FSL (indicating Alarm 1, full scale low), and the parameter value is 10.0.
2.4.4 To change the value of a parameter
First, select the required parameter. The parameter name is shown in the upper readout and
the parameter value in the lower readout.
To change the parameter value, press either or . During adjustment, single presses
change the value by one digit.
Keeping the button pressed speeds up the rate of change.
Two seconds after releasing either button, the display blinks to show that the controller has
accepted the new value.
Parameter name
Parameter value
1FS L
10.0