Thermcraft XST-3-0-36-3V - Manual (Page 196)

Operation Installation and Operation Handbook
2-12 2416 Controller
2.6 PARAMETER TABLES
Name Description
Home list Extra parameters may be present if promote feature has been used.
Home Measured value and Setpoint
OP % Output level
SP Target setpoint (if in Manual mode )
m-A Auto-man select
AmPS Heater current (With PDSIO mode 2)
C.id Customer defined identification number
run Program run list − Present only in setpoint programming controllers
PrG Active program number (Only on 4 program versions)
StAt
Program status (
OFF, run, hoLd, HbAc, End)
PSP Programmer setpoint
CYC Number of cycles remaining in the program
SEG Active segment number
StyP Active segment type
SEG.t Segment time remaining in the segment units
tGt Target setpoint
rAtE Ramp rate (if a rate segment)
PrG.t Program time remaining in hours
FASt
Fast run through program (
no / YES)
out.n
Event output states (
OFF / on)
(not 8-segment programmer)
SYnc
Not operational in 2416. Set to
no.
SEG.d
* Flash active segment type in the lower readout of the home display (
no / YES)
ProG Program edit list − Present only in setpoint programming controllers
PrG.n Select program number (Only on 4 program versions)
Hb Holdback type ( OFF, Lo, Hi, or bAnd)
Hb V Holdback value (in display units)
rmP.U Ramp
units (
SEc, min, or Hour) [for both rmP.r and rmP.t type segments]
dwL.U Dwell units ( SEc, min, or Hour)
CYC.n
Number of program cycles (
1 to 999, or ‘cont’)
SEG.n Segment number
tYPE Segment type: ( End) (rmP.r=ramp rate) (rmP.t=ramp time) (dwel) (StEP) (cALL)
* This parameter can only be changed when the program is in reset
Continued on next page: