Thermcraft XST-3-0-36-3V - Manual (Page 225)

Installation and Operation Handbook Programmer Operation
2416 Controller 5-9
Power fail strategy
Use
or to select:
• cont : Continue from last setpoint
• rmP.b : Ramp from PV to setpoint at last ramp rate
• rSEt : Reset the program
Press
Servo type
Use or to select:
• to.PV Servo to PV
• to.SP Servo to SP
Press
Event Outputs (not in 8-segment programmer)
Use or to select:
• no : Event outputs disabled
• YES : Event outputs enabled
Note: The term
Sync appears on 2416 but is not operational
and should be set to
no. It appears in order to maintain software
consistency with 2408 and 2404 controllers.
Press to return to the list header
Pwr.f
cont
srvo
to.pV
out
no
sync
no