Thermcraft XST-3-0-36-3V - Manual (Page 250)

User Calibration Installation and Operation Handbook
7-4 2416 Controller
Set Offset 1
Use or to set the offset value of Process Value 1
(PV1).
The offset value is in display units.
Press
The table below shows the parameters which appear after
‘
OFS.1’. These are all read only values and are for information.
Press to step through them.
mV.1 IP1 measured value (at terminals)
CJC.1 IP1 Cold Junction Compensation
Li.1 IP1 Linearised Value
PV.SL Not available in Model 2416
If you do not want to look at these parameters, then press
and this returns you to the ‘
iP-LiSt’ header.
To protect the calibration against unauthorised adjustment, return
to Operator level and make sure that the calibration parameters
are hidden. Parameters are hidden using the ‘Edit’ facility
described in Chapter 3, Access Levels.
OFS.1
0
See table on the
right for additional
parameters