Thermcraft XST-3-0-36-3V - Manual (Page 261)

Installation and Operation Handbook Load Current Monitoring and Diagnostics
2416 Controller 8-7
Press to show
OUT.L
Press or
to show
0.0
Warning! If OUT.L is
set to any figure other
than 0 the minimum
output power will be
limited to this level. You
must ensure that this
does not present an
unsafe condition for the
process
This is the minimum
output power
To set the min
output power to 0
Press to show
OUT.H
Press or
to show
100.0
This is the maximum
output power
To set the max
output power to 100
Press to show
SEnS
Press or
to show
nor
This sets the output
signal to normal for
heating control
SEnS
nor
OUT.L
0.0
OUT.H
1 0.0