Rally Armor 2015+ Subaru Outback - Manual (Page 3)

IMF 34/36
Version 1.0 Release Date 10.27.2014
3
• (Figure G) Legacy-Place wide mounting point of rear bracket between the bumper skin and the insert Place a washer (SmWash) over
a screw (1.5SS) through the mounting point into the insert. Do not fully tighten as you will adjust the angle of the bracket during mud
flap installation.
• (Figure H) Outback example of Figure (G)
• (Figure I)
Place a polygon edge clip (PolCl) over the narrow mounting point of the bracket.
• (Figure J) Place the mud flap with the logo facing the rear of the vehicle, against the corresponding mounting points on the fender
liner. Place a washer (SmWash) over a screw (1.5SS) through the flap into the each of the mounted clips. Adjust inner portion back to a
parallel position, and to ensure proper tire clearance.
• (Figure K) Expanded view rear mounting. Leave mounting point loose during adjustment as to ensure the mud flap is flat.
• (Figure L) Align outer edge of the flap by incrementally adjusting the angle of the flap and bracket and walking away from the vehicle
until the flap is perpendicular to even ground. Tighten all mounting screws and bracket screw only until snug and flush with the
surface of the mud flap. Do not over tighten. Ensure mud flap is flush against mounting points by tightening all points only after
alignment.