Rally Armor 98 to 02 Subaru Forester User Manual
Page 3
IMF13
Version 1.1 Release Date 3.25.2010
3
• (Figure G) Re‐install plastic shield.
• (Figure H) Position the rear mud flap with logo facing the rear of the vehicle. Install a long screw (1.5SS) and a large washer (Wash),
through the mud flap mounting point in to each of the two outer bumper mounting points. Use a small screw (1SS) and a large washer
(Wash) on the innermost bracket mounting point. Adjust mud flap and bracket first before tightening all mounting points.
• (Figure I) Check for proper threading of screws into clips prior to final tightening.
Align outer edge of the flap by incrementally adjusting the
side to side, lower/upper portion of the flap and walking
away from the vehicle until the flap is perpendicular to
even ground. Tighten all mounting screws only until snug
against washer. Do not over tighten.
All content including text, graphics, and logos are property of Rally Armor LLC.