Dell PowerVault 735N (Rackmount NAS Appliance) - Manual (Page 106)

A-6 Installation and Troubleshooting Guide
Interposer Board Connectors
Figure A-3 shows the connectors and sockets located on the interposer board.
Figure A-3. Connectors on the Interposer Board
Disabling a Forgotten Password
NOTE: To perform this procedure, you must connect a keyboard, mouse, and monitor
to your system.
The system's software security features include a system password and a setup
password, which are discussed in detail in Chapter 3, “Using the System Setup Pro-
gram,” in the
User's Guide . A password jumper on the system board enables these
password features or disables them and clears any password(s) currently in use.
NOTICE: Dell recommends that the system password be left in the Not
Enabled (default) setting. When operating your system in the headless
configuration, you will not be able to input a system password in order to
reboot the system.
To disable a forgotten system password or setup password, perform the following
steps.
NOTICE: See “Protecting Against Electrostatic Discharge” in the safety
instructions at the front of this guide.
1. Remove the right-side system cover.
2. Refer to Figure A-1 for the location of the password jumper (labeled “PASSWD”)
on the system board.
3. Remove the jumper plug from the PASSWD jumper.
system board
interface cable
connector (P1) interposer board
power cable
connector (P3)
cooling fans
wiring harness
connector (P2)
control panel cable connector
diskette drive/CD-ROM drive interface connector
87MPGbk0.book Page 6 Wednesday, December 13, 2000 2:14 PM