Dell PowerVault NX3000 - Manual (Page 94)

94
Installing System Components
VFlash Media (Optional)
The optional VFlash media is a Secure Digital (SD) card that can be used
with the optional iDRAC6 Enterprise card. See "Integrated Dell Remote
Access Controller 6 (iDRAC6) Enterprise Card (Optional)."
1 Locate the VFlash media slot on the back of the system and insert the
contact-pin end of the SD card (with the label side facing up) into the
slot. See "Back Panel Features and Indicators" for the slot location.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2 Press inward on the card to lock it into the slot.
To remove the card, push inward on the card to release it, and pull the card
from the card slot.
NIC Hardware Key
iSCSI and other future functionalities for the system’s embedded NICs are
enabled by installing an optional NIC hardware key in the ISCSI_KEY socket
on the system board.
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
NOTE:
When future NIC functionality is supported, you must replace the original
NIC hardware key (if installed) with a new hardware key.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System."
3 Locate the ISCSI_KEY connector on the system board. See Figure 6-2.
4 Insert the NIC hardware key into the connector onto the board. See
Figure 3-11.