Dell PowerVault NX3000 - Manual (Page 147)

Installing System Components
147
Figure 3-36. System Board Removal
Installing the System Board
1 Unpack the new system board and remove the label placard that is inserted
in the memory module socket.
2 Remove the labels from the placard and affix them to the information tag
on the front of the system. See Figure 1-1.
3 Transfer the processors and heat sinks to the new system board. See
"Removing a Processor."
4 Remove the memory modules and transfer them to the same locations on
the new board. See "Removing Memory Modules" and "Installing Memory
Modules."
5 Install the new system board:
a Angle the system board as you lower it into the chassis and set the
board flat inside the chassis.
b Maneuver the system board so that all of the retention hooks on the
chassis are inserted into the retention slots on the system board.
1 system-board tray riser release pin 2 system board
2
1