Dell PowerVault NX3000 - Manual (Page 128)

128
Installing System Components
Mode-Specific Guidelines
Three memory channels are allocated to each processor. The number of
channels and allowable configurations depend on the memory mode selected.
Advanced ECC (Lockstep) Mode Support
In this configuration, the two channels closest to the processor are combined
to form one 128-bit channel. This mode supports SDDC for both x4- and x8-
based memory modules. Memory modules must be identical in size, speed,
and technology in corresponding slots.
Memory Mirroring Support
The system supports memory mirroring if identical memory modules are
installed in the two channels closest to the processor (memory is not installed
in the farthest channel). Mirroring must be enabled in the System Setup
program. In a mirrored configuration, the total available system memory is one-
half of the total installed physical memory.
Optimizer (Independent Channel) Mode
In this mode, all three channels are populated with identical memory
modules. This mode permits a larger total memory capacity but does not
support SDDC with x8-based memory modules.
A minimal single-channel configuration of one 1-GB memory module per
processor is also supported in this mode.
Table 3-2 and Table 3-3 show sample memory configurations that follow the
appropriate memory guidelines stated in this section. The samples show
identical memory-module configurations and their physical and available
memory totals. The tables do not show mixed or quad-rank memory-module
configurations, nor do they address the memory speed considerations of any
configuration.