Dell PowerVault NX3000 - Manual (Page 50)

50
About Your System
Unable to launch
System Services
image. System
halted!
System halted after F10
keystroke because System
Services image is either
corrupted in the system
firmware or has been lost
due to system board
replacement. Restart the system and
update the Unified Server
Configurator repository to
the latest software to restore
full functionality. See the
Unified Server Configuration
user documentation for more
information.
The iDRAC6 Enterprise card
flash memory may be
corrupted. Restore the flash memory
using the latest version on
support.dell.com. See the
iDRAC6 user's guide for
instructions on performing a
field replacement of the flash
memory.
Unexpected
interrupt in
protected mode
Improperly seated memory
modules or faulty
keyboard/mouse controller
chip. Reseat the memory modules.
See "Troubleshooting System
Memory." If the problem
persists, see "Getting Help."
Unsupported CPU
combination
Unsupported CPU
stepping
detected
Processor(s) is not supported
by the system. Install a supported processor
or processor combination.
See "Processors."
Unsupported DIMM
detected. The
following DIMM
has been
disabled: x
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled. Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."
Unsupported
memory
configuration.
DIMM mismatch
across slots
detected:
x,x,...
Invalid memory
configuration. Memory
modules are mismatched in
the specified slots. Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."
Table 1-2. System Messages (continued)
Message Causes Corrective Actions